BC-UNIKat/LSHF

Quality Construction — 4 shielded twisted pairs (U/FTP) of 23AWG solid copper conductors are cabled together in an unshielded outer jacket.
Optimized for Kramer Hardware
HDBaseT Recommended — www.hdbaset.org/hdbaset–recommended–cables/.
Reaction to Fire Classification — Dca–s2,d1,a1 (optional: B2ca–s1,d1,a1).
RJ–45 Connector — The larger diameter 23AWG twisted pair cable requires a special RJ–45 connector.
Length — Available in reel boxes of 100m (328ft) & wooden drums of 305/500m (1000/1640ft).

Technical specifications

Twisted pair category	CAT6A U/FTP
Number of conductors	4 x 2
Inner conductor	1 x 0,56 mm
Conductor material	Annealed Copper
Conductor cross section	0.25 mm²
AWG	23
Insulation material	Polyethylene film-porous film high density (Skin-Foam-Skin HDPE)
Insulation diameter	1,33 mm ±0,1 mm
Insulation color	orange, orange with white green, blue with white blue, green with white brown, brown with white
Screen common	No
Screen individual	Aluminum foil at Mailare (Al-Mylar)
Ground wire	0.4 mm ± 0.1 mm; 90 % tinned copper
Outer shell material	Low-house polymer without halogen (LSHF)
Outer shell diameter	7,2 mm ±0,2 mm
Outer shell thickness	≧ 0,5 mm
Outer shell color	Blue
Electrical parameters
Wave impedance	100 ohms ± 15 ohm
DC conductor resistance per 1 km	79.8 Ohm Max.
Ohmic asymmetry	< 1,5 %
Signal Propagation Rate (VOP)	0,76
Working pair capacity (electrical)	≦ 42 PF / M
Capacitive asymmetry of the pair relative to the "ground"	≦ 1500 PF / km
Propagation delay mismatch at 100 m	10 ns.
Dielectric strength	2.5 kV post. (2 s)
Insulation resistance per 1 km	>5   gom
Rated voltage	30 V
Performance characteristics
Maximum pulling tension	100 N.
Minimum bend radius	60 mm when mounting 50 mm during operation
Operating temperature range	−20…+60 °C
Storage temperature range	0…+50 °C
Temperature range during installation	0…+50 °C
Compliance
Flame Propagation Test	IEC 60332-1
Smoke Density Test	IEC 61034
Halogen Acid Gas Emission Test	IEC 60754
Cable standards	ANSI TIA/EIA-568-C.2:2009, IEC 61156-5:2012 (Ed. 2.1), EN 50173-1:2011, EN 50173-2:2007 (adjusted A1:2010), EN 50288-10-1:2012, ISO/IEC 11801:2011 (Ed. 2.2)